Skip to content

Help Centre

Search For Topics
< All Topics
Print

BeamOS – Graphs

BEAM OS Logo

Summary

The Graphs section contains various graphs that display various statistical data changes in real-time. This chapter is an overview of the Graphs section in BEAM routers.

Mobile Strength

The Mobile Signal Strength graph displays mobile signal strength (RSSI, measured in dBm) value changes over a period of 3 minutes. The figure below is an example of the Mobile Signal Strength graph:
BeamOS status graphs mobile signal strength screen

Load

The Realtime Load section displays a tri-graph that illustrates average CPU load values in real time. The graph consists out of three color coded graphs, each one corresponding to the average CPU load over 1 (red), 5 (orange) and 15 (yellow) most recent minutes.

The figure below is an example of the Realtime Load graph:

BeamOS status graphs load realtime load screen

Traffic

The Realtime Traffic graphs provide users with the possibility to monitor average inbound and outbound traffic over the course of 3 minutes; each new measurement is taken every 3 seconds. The graphs consist out of two color coded graphs: the green graph shows the outbound traffic, the blue graph shows the inbound traffic. Although not graphed, the page also displays peak loads and averages of inbound and outbound traffic. Bridge

The figure below is an example of the Realtime traffic graph for the Bridge connection:

BeamOS status graphs traffic realtime screen
Graph
Description
Bridge
Cumulative graph, which encompasses wired Ethernet LAN and the wireless network
LAN
Displays traffic that passes through the LAN network interface(s) in graph form
WiFi
Displays traffic that passes through the WiFi interface in graph form
WAN (Wired) | WAN (WiFi) | Mobile
Displays traffic that passes through the current active WAN connection in graph form

Wireless

The Realtime Wireless graph displays the wireless radio signal strength, signal noise, average and peak signal levels and the theoretical maximum channel permeability. The graph below the WiFi signal graph displays the Phy Rate for the wireless connection.

The figures below are examples of both Wireless graphs:

BeamOS status graphs wireless realtime wireless signal screen
BeamOS status graphs wireless realtime wireless phy rate screen

Connections

The Realtime Connections graph displays currently active network connections with the information about network, protocol, source and destination addresses and transfer speed. The table the graph displays basic information on active connections

The figures below are examples of both of the Realtime Connections graph and the corresponding table:

BeamOS status graphs connections realtime connections graph screen
Previous BeamOS – Routes
Next BeamOS – Mobile Traffic
Table of Contents

SAVE

10%

It only takes a few seconds

DON'T MISS OUT

SUBSCRIBE AND SAVE 10%

GET EXCLUSIVE OFFERS AND THE LATEST PRODUCT NEWS.

WE WILL GIVE YOU A 10% OFF VOUCHER CODE FOR YOUR NEXT ORDER AS A THANK YOU!